attached mail follows:
Chris,
Other options to try may involve slighlty changing the temperature of
the support (base) material. Another "trick" requires keeping a close
eye on the first few layers.... Try pausing the machine and bumping up
the "Z" level using the control keys - just enough to prevent and
minimize the area of the next layer from sticking (thermally adhering)
too much! .......... Good luck!
Jim Pike
Chris Derdas wrote:
>
> We own an FDM 1650 which is controlled by Quickslice 4.0 but although
> the XYZ offset calibration reads OK we cannot remove the base from any
> part . We have just changed the tips (T12) ,but nothing seems to work .I
> would welcome any feedback
>
> Thanking you in advance
>
> Christos Derdas
> Research Assistant
> LABORATORY FOR MANUFACTURING SYSTEMS
> DEPARTMENT OF MECHANICAL ENGINEERING AND AERONAUTICS
> UNIVERSITY OF PATRAS
> PATRAS 26110, GREECE
>
> For more information about the rp-ml, see http://ltk.hut.fi/rp-ml/
For more information about the rp-ml, see http://ltk.hut.fi/rp-ml/
This archive was generated by hypermail 2.1.2 : Tue Jun 05 2001 - 23:03:05 EEST