At 09:43 AM 4/18/00 +0100,
Chris.
Sutcliffe wrote:
A
little while ago maybe up to 12 months I put a request on the list for
info on companies who produce small diameter milling cutters. One of our
number was kind enough to reply with the names of two companies
unfortunately however I have lost (put in a safe place and forgotten
where the safe place is) the info so can whoever sent the original info
send it again.
Dear Chris,
Most tool suppliers should have small cutters in their sales program, so
I think
it would pay off to do some local shopping first.
If this does not work out:
Our local supplier is Clarkson:
www.clarkson.nl
In their series of carbide cutters they have a line of 'miniature
tools'
including diameters from 0.2 to 2.0 mm in steps of 0.1 mm
An alternative is Fischer in Germany, specialised in jewellers
tools,
www.fischer-pforzheim.com
They sell many small tools as well, and have HSS tools which will
be
considerably cheaper.
Best Regards,
Lex Lennings.
This archive was generated by hypermail 2.1.2 : Tue Jun 05 2001 - 23:03:19 EEST