In a message dated 5/12/00 12:03:02 PM Eastern Daylight Time, rp2@xs4all.nl
writes:
<< I had on stock and mayby the problem was that this
stuff had a too low viscosity. I placed the parts with epoxy in the vacuum
chamber, but the layer epoxy on the part was too thick and not constant. >>
I haven't tried it, but I read once about using acetone to thin epoxy to use
as a sealant for boat models. The epoxy will still set up, but will be thin
enough to soak in.
Andy Scott
Lockheed Martin Aero Sys
For more information about the rp-ml, see http://ltk.hut.fi/rp-ml/
This archive was generated by hypermail 2.1.2 : Tue Jun 05 2001 - 23:03:29 EEST