Modelmaker II big and small parts

• Next message: Michael Schmit: "JOB OPENING"
• Previous message: Scott Nelson: "Re: OT:Linear length of material on a roll"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

Hello there,

I am back againg. Can somebody help me in Europe making Volumeous parts and
small parts (wall thichness about 1 mm), for both nice surface quality and
tolerances? Can you also do the castings?

Please response if you have any experience about this and can tell me about
what is and what is not possible. Then I can give you more information.

Thanks again, just send it directly to me please.

Wilfred Backers

Project: WAX parts and castings
________________________________________________________

TNO Industrial Technology
Department Industrial Prototyping
P.O.Box 5073
2600 GB Delft (The Netherlands)
tel: +31 (0)15- 2 608 889
fax: +31 (0)15- 2 608 725
E-mail: w.backers@ind.tno.nl
http://www.ind.tno.nl/en/productiondevelopment/prototyping/index.html
________________________________________________________

For more information about the rp-ml, see http://ltk.hut.fi/rp-ml/

• Next message: Michael Schmit: "JOB OPENING"
• Previous message: Scott Nelson: "Re: OT:Linear length of material on a roll"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

This archive was generated by hypermail 2.1.2 : Tue Jun 05 2001 - 23:03:32 EEST