Hi RP world,
Has anyone who uses a thermojet any good ideas for clean removal of the
support structure.
I have found that the finished surface is quite rough and would appreciate
any ideas for getting it a bit smoother so that there is less machining to
do on the investment castings.
Thank you in advance.
Darryl Thorne.
Apollo Fire Detectors Ltd.
36,Brookside Road,
Havant.
Hants.
England
PO9 3AB.
Tel:+44 023 9249 2412
Fax:+44 023 9249 2754
e-mail: Darryl.thorne@apollo-fire.co.uk
*************************************************************************************************
The information transmitted is intended only for the person or entity to which it is addressed and may contain confidential and/or privileged material. If you are not the addressee, any disclosure, reproduction, copying, distribution, or other dissemination or use of this communication is strictly prohibited. If you have received this transmission in error please notify the sender immediately and then delete this e-mail.
E-mail transmission cannot be guaranteed to be secure or error free as information could be intercepted, corrupted, lost, destroyed, arrive late or incomplete, or contain viruses.
The sender therefore does not accept liability for any errors or omissions in the contents of this message which arise as a result of e-mail transmission. If verification is required please request a hard copy version.
*************************************************************************************************
For more information about the rp-ml, see http://ltk.hut.fi/rp-ml/
This archive was generated by hypermail 2.1.2 : Tue Jun 05 2001 - 23:03:37 EEST