We use a Scotch Brite pad to lighly "sand" the
support areas. We spray a minimal amount of
"citrus cleaner" on a lapping plate. We lap the
thermojet model. The areas which do not allow
flat sanding, we spray the citrus cleaner on the
back of sand paper or a flat tool and smooth the
surfaces. Be sure to allow ample time for the
model to completely dry after sanding.
For more information about the rp-ml, see http://ltk.hut.fi/rp-ml/
This archive was generated by hypermail 2.1.2 : Tue Jun 05 2001 - 23:03:41 EEST