Archie,
If you have Surfacer, go to RPM/Cut/Arbitrary Cut. You can then draw a
sawtooth or zig zag line through your part. Be sure to draw to the
extents of the part and to pick the Cap Model in the dialog box before
you begin.
If you have just the RPM module, the command is Create/Cut/Arbitrary
Cut. If you have any other questions, please let me know. Good luck!
Bob Gansen
______________________________ Reply Separator _________________________________
Subject: Bob,
Author: alswan@Roushind.com at Johnson_Controls
Date: 6/22/00 9:14 AM
Bob,
Could you elaborate on "I use Imageware to puzzle cut my .stl files".
I was not aware that Imageware could do a cut like that. If you could tell me
where in the software to find it I would greatly appreciate it.
Thanks
Archie Swanner
Roush Industries
Rapid Prototype Department
(734)779-7463
(734)779-7906 - fax
alswan@roushind.com
For more information about the rp-ml, see http://ltk.hut.fi/rp-ml/
This archive was generated by hypermail 2.1.2 : Tue Jun 05 2001 - 23:03:44 EEST