Translator from Pro-E to Mech Desktop

From: Mkarimi (mkarimi@rcbi.org)
Date: Thu Jul 27 2000 - 23:57:26 EEST

Next message: Alain BERNARD: "Re: associations of RP"
Previous message: Jeff McBride: "roll call"
Next in thread: Craig Topp: "RE: Translator from Pro-E to Mech Desktop"
Maybe reply: Craig Topp: "RE: Translator from Pro-E to Mech Desktop"
Maybe reply: Mkarimi: "RE: Translator from Pro-E to Mech Desktop"
Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

Is there a translator out there that converts Pro-E (.prt) files
into Mechanical Desktop (.dwg) files? Thanks for your assistance.

        M. Karimi
        Robert C Byrd Institute
        (304) 696-6370
        mkarimi@rcbi.org

For more information about the rp-ml, see http://ltk.hut.fi/rp-ml/

Next message: Alain BERNARD: "Re: associations of RP"
Previous message: Jeff McBride: "roll call"
Next in thread: Craig Topp: "RE: Translator from Pro-E to Mech Desktop"
Maybe reply: Craig Topp: "RE: Translator from Pro-E to Mech Desktop"
Maybe reply: Mkarimi: "RE: Translator from Pro-E to Mech Desktop"
Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

This archive was generated by hypermail 2.1.2 : Tue Jun 05 2001 - 23:03:58 EEST