STL Ascii

From: Pedro Garayo (pedgar@cidaut.es)
Date: Fri Sep 01 2000 - 17:35:23 EEST

Next message: Delft Spline Systems: "Re: STL Ascii"
Previous message: M&PR: "RE:Stereolithography Videos"
Next in thread: Delft Spline Systems: "Re: STL Ascii"
Reply: Delft Spline Systems: "Re: STL Ascii"
Reply: Gert Mensing: "Re: STL Ascii"
Reply: Pedro Garayo: "Re: STL Ascii"
Maybe reply: C. Brock Rooney: "Re: STL Ascii"
Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

Hello list,

I have been asked to make an stl file in ascii format starting from the
stl file in binary format. What software could I use?
Thanks in advance.

Pedro.

--
+----------------------------+------------------+
|     Pedro Garayo           | FUNDACION CIDAUT |
|   R&D Project Engineer     |   Parque Tec.    |
| Product Design&Processing  | Boecillo  P209   |
| Rapid Product Development  | 47151 Valladolid |
|    Tel:+34983548035        |      SPAIN       |
|  mailto:pedgar@cidaut.es   |                  |
+----------------------------+------------------+
For more information about the rp-ml, see http://ltk.hut.fi/rp-ml/

Next message: Delft Spline Systems: "Re: STL Ascii"
Previous message: M&PR: "RE:Stereolithography Videos"
Next in thread: Delft Spline Systems: "Re: STL Ascii"
Reply: Delft Spline Systems: "Re: STL Ascii"
Reply: Gert Mensing: "Re: STL Ascii"
Reply: Pedro Garayo: "Re: STL Ascii"
Maybe reply: C. Brock Rooney: "Re: STL Ascii"
Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

This archive was generated by hypermail 2.1.2 : Tue Jun 05 2001 - 23:04:13 EEST