Re: Die Cast Prototypes

From: Bradley C. Fox (bfox@rapid-design.com)
Date: Tue Oct 10 2000 - 16:43:13 EEST

Next message: bolson@molex.com: "Re: Die Cast Prototypes"
Previous message: H.Byun: "powder ratio for SLS 2000"
In reply to: Impact - Doug Johnson: "Die Cast Prototypes"
Next in thread: bolson@molex.com: "Re: Die Cast Prototypes"
Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

Doug:
Our 3D Keltool inserts can be used in die casting. We've had quite a few
inserts used in a PRODUCTION setting when zinc is used. They would be
considered prototype/short run for aluminum.

Thanks!

Brad Fox
Rapid Tooling Technologies
Ph: 651-483-2703

For more information about the rp-ml, see http://ltk.hut.fi/rp-ml/

Next message: bolson@molex.com: "Re: Die Cast Prototypes"
Previous message: H.Byun: "powder ratio for SLS 2000"
In reply to: Impact - Doug Johnson: "Die Cast Prototypes"
Next in thread: bolson@molex.com: "Re: Die Cast Prototypes"
Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

This archive was generated by hypermail 2.1.2 : Tue Jun 05 2001 - 23:04:31 EEST