Elaine, list,
Here at CRDM, we're making thin-walled (<1.5mm) electroforms, and backfilling
them with a low melt point alloy. The electroform is built up into a
pre-machined copper frame which has been inserted into an RP master pattern (we
tend to prefer SL and THJ).
These backfilled electroforms are then attached to the pallet system (3R)
accurately by means of the copper frame and used on an EDM machine.
Allan.
Elaine Hunt wrote:
> Anyone doing anything with these topics that is of interest to the group?
>
> elaine
-- Allan E W Rennie Research Engineer Centre for Rapid Design and Manufacture Buckinghamshire Chilterns University College Queen Alexandra Road High Wycombe Bucks HP11 2JZ -------------------------------------------- Tel: +44 (0)1494 605085 Fax: +44 (0)1494 538593 Mob: +44 (0)7930 431469 Email: allan.rennie@bcuc.ac.uk --------------------------------------------For more information about the rp-ml, see http://ltk.hut.fi/rp-ml/
This archive was generated by hypermail 2.1.2 : Fri Jan 04 2002 - 09:56:45 EET