Re: RP and Thermoforming

From: eschl (eschl@ikpsun2.verfahrenstechnik.uni-stuttgart.de)
Date: Thu Feb 22 2001 - 20:34:05 EET

Next message: KDenton@williams-int.com: "RE: Bead Blaster"
Previous message: Doug Groh: "Re: Bead Blaster"
In reply to: Doug Groh: "Re: RP and Thermoforming"
Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

There is a company in Austria, which also uses thermoformed coloured
films which are then injected with thermoplastics from behind.

http://www.apt.at

However, I think, in general thermoforming moulds are easily to mill so
are there real advances in useing RP-moulds ?

Johannes Eschl

-- Johannes Eschl IKP, Institut fuer Kunststoffkunde und Kunststoffpruefung, Universitaet Stuttgart Boeblingerstr. 78E, D-70199 Stuttgart Tel.: (+49) 0711 / 641 23 06 Fax : (+49) 0711 / 641 22 64 E-Mail : eschl@ikp2.uni-stuttgart.de johannes.eschl@eschl.de WWW: http://www.ikp2.uni-stuttgart.de/RP_IKP www.raptec.org

For more information about the rp-ml, see http://ltk.hut.fi/rp-ml/

Next message: KDenton@williams-int.com: "RE: Bead Blaster"
Previous message: Doug Groh: "Re: Bead Blaster"
In reply to: Doug Groh: "Re: RP and Thermoforming"
Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

This archive was generated by hypermail 2.1.2 : Fri Jan 04 2002 - 09:56:53 EET