AMD 4.0 stl settings

• Next message: Kwok Kai Thong, Mariner: "RE: AMD 4.0 stl settings"
• Previous message: Paul-Henri Tinguely: "Re: Scanning an aircraft"
• Next in thread: Kwok Kai Thong, Mariner: "RE: AMD 4.0 stl settings"
• Maybe reply: Kwok Kai Thong, Mariner: "RE: AMD 4.0 stl settings"
• Reply: Rafael Santillan: "Re: AMD 4.0 stl settings"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

Dear All,
 
a customer of ours is trying to create an stl file for a small component.
Normally I would have estimated only 1/2 a meg for the file size only they
are coming out with a binary file size of 27Mb.
 
Can anyone give me some optimum settings for the following parameters from
AutoDesk Mechanical Desktop 4.0
 
Angular Tolerance
Aspect Ratio
Surface Tolerance
Vertex Spacing
 
Thanks in Advance
 
Ross Nicholls
General Manager
Malcolm Nicholls Limited
Waterloo Ind. Est.
Bidford-on-Avon
Warwickshire
B50 4JH
T 01789 490382
F 01789 490130
E ross@mnl.co.uk
W www.mnl.co.uk

For more information about the rp-ml, see http://ltk.hut.fi/rp-ml/

• Next message: Kwok Kai Thong, Mariner: "RE: AMD 4.0 stl settings"
• Previous message: Paul-Henri Tinguely: "Re: Scanning an aircraft"
• Next in thread: Kwok Kai Thong, Mariner: "RE: AMD 4.0 stl settings"
• Maybe reply: Kwok Kai Thong, Mariner: "RE: AMD 4.0 stl settings"
• Reply: Rafael Santillan: "Re: AMD 4.0 stl settings"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

This archive was generated by hypermail 2.1.2 : Fri Jan 04 2002 - 09:57:03 EET