LM6 Aluminium Castings from RP Patterns

From: Mullins, John (jmullins@tycoelectronics.com)
Date: Fri May 04 2001 - 11:29:22 EEST

Next message: Paul Finelt - Optimum Online: "RE: Sanders Wax"
Previous message: Joshua Bleeth: "3d staff"
Next in thread: Mike Feygin: "RE: LM6 Aluminium Castings from RP Patterns"
Reply: Mike Feygin: "RE: LM6 Aluminium Castings from RP Patterns"
Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

Hi all,

I'm looking for advice for casting grade LM6 aluminium
prototype parts from LOM/SLA masters (or any applicable technology.)

Parts are relatively small (1" x 1"x 2" approx) and uncomplicated.
Quantity would be somewhere in the region of 100-150 parts.
Some machining would also be required post casting.

What would be the most economical casting technique for this application?

Regards,
John Mullins
Development Engineer

Tyco Electronics Power Division (Raychem)

For more information about the rp-ml, see http://ltk.hut.fi/rp-ml/

Next message: Paul Finelt - Optimum Online: "RE: Sanders Wax"
Previous message: Joshua Bleeth: "3d staff"
Next in thread: Mike Feygin: "RE: LM6 Aluminium Castings from RP Patterns"
Reply: Mike Feygin: "RE: LM6 Aluminium Castings from RP Patterns"
Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

This archive was generated by hypermail 2.1.2 : Fri Jan 04 2002 - 09:57:13 EET