Have you checked the plotter's push-button on the back side of machine, over
the general and heater switches? This message appears when then button is
off. I hope this helps.
Panagiotis Moustakas
Research assistant
Lab for Manufacturing Systems
Director: Prof. G.Chryssolouris
Department of Mechanical Engineering & Aeronautics
University of Patras
Rio 261 10
Patras
Greece
Fax: + 3 061 997744
Work: + 3 061 997264
reza moini wrote:
> Dear Sir
> I have a LOM machinefrom Helisys (LOM1015) but when I
> start it,this error message will appear: "can not
> connect XY plotter"
> How can I solve this problem?
> Thank you
> REZA MOINI
>
> __________________________________________________
> Do You Yahoo!?
> Make international calls for as low as $.04/minute with Yahoo! Messenger
> http://phonecard.yahoo.com/
>
> For more information about the rp-ml, see http://rapid.lpt.fi/rp-ml/
For more information about the rp-ml, see http://rapid.lpt.fi/rp-ml/
This archive was generated by hypermail 2.1.2 : Fri Jan 04 2002 - 09:57:33 EET