Re: Large Part Prototype Injection Molding ?

• Next message: Elaine Hunt: "new system"
• Previous message: Michael Priest: "Re: Thermal degradation of polymers?"
• In reply to: Cindy Fine: "Large Part Prototype Injection Molding ?"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

At 04:40 PM 7/26/2001 -0400, Cindy Fine wrote:
>I have been asked by a customer if there are any companies who offer
>prototype or even low volume injection molding for very large parts. They
>wish to be able to prototype using the production resins, etc.
>For size think dash boards or panels for large construction equipment.

try Materialise in Belgium. They can do the entire dash board. Real size.

Elaine

*******************************************************************
Opinions, suggestions, and other controversial matter VOID where prohibited.

"You must be the change you wish to see in the world."
Mahatma Gandhi

******************************************************************

Elaine T. Hunt, Director elaine.hunt@ces.clemson.edu
Laboratory to Advance Industrial Prototyping
Clemson University 206 Fluor Daniel Bldg.
Clemson, SC 29634-0925
864-656-0321 (voice) 864-656-4435 (fax)
http://www.vr.clemson.edu/credo/persall/persall.html
http://www.vr.clemson.edu/credo/rp.html

For more information about the rp-ml, see http://rapid.lpt.fi/rp-ml/

• Next message: Elaine Hunt: "new system"
• Previous message: Michael Priest: "Re: Thermal degradation of polymers?"
• In reply to: Cindy Fine: "Large Part Prototype Injection Molding ?"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

This archive was generated by hypermail 2.1.2 : Fri Jan 04 2002 - 09:57:34 EET