Beste Bart,
Earlier today I replied to the original question without cc-ing to the
rp-ml, however now I cannot resist: your "the only machine" is not
true as DeskProto plus desktop CNC milling machine comes very
close as well. In fact only the Z of the envelope does not fit: the
CPM 4030 machine that we sell has 4.8 " Z instead of 6.
ALL other requirements, including "nice" and "bonus" are met.
The price even is far below the available budget.
So far a small Dutchman-to-Dutchman correspondence on the rp-ml
Tot ziens op de ESEF beurs,
Lex Lennings
At 12:05 PM 20/12/2001, you wrote:
>To my best knowledge the only machine that comes close fulfilling your
>wishes is the Stratasys Prodigy. See www.stratasy.com
>
>----- Original Message -----
>From: "Scott Nelson" <scott@colpittsdesign.com>
> > To narrow the field down the machine should be capable of building
> > plastic (prefer ABS - alternately nylon or PVC) parts pretty quickly.
> > A build envelope of 12x x 8y x 6z would be adequate. A price below 40k
> > US$ would also be nice, a table top machine would also be a bonus.
----------------------------------------------------------------------
Delft Spline Systems, The Netherlands.
We offer DeskProto: affordable Rapid Prototyping using CNC milling.
mailto:info@spline.nl --- website: http://www.deskproto.com
For more information about the rp-ml, see http://rapid.lpt.fi/rp-ml/
This archive was generated by hypermail 2.1.2 : Fri Jan 04 2002 - 09:58:20 EET