From: Timothy J Gornet (tim.gornet@louisville.edu)
Date: Tue Mar 26 2002 - 20:18:55 EET
Mr. Rossini,
You need to use ethanol and lens cleaning tissues. It is explained in
depth in the Reference Guide. In the Build Setup software go to Help,
Online Documentation. Then select the Reference Guide. Then go to
Hardware Maintenance, Beam Delivery System Maintenance. The first
section is on cleaning the laser window. It should be done before EVERY
build. Do not let it build up or it can be impossible to remove. It only
takes a couple of minutes.
Good luck,
Tim
Tim Gornet Computer Aided Engineering Consultant
INTERNET: tim.gornet@louisville.edu
SLUGNET: Vogt Bldg. Rm 101, University of Louisville, Louisville, KY
40292
PHONENET: (502)852-0714 FAXNET: (502)852-8890
Rapid Prototype Center
>>> Mariapia Rossini <mprossini@eosimage.it> 03/26/02 12:02PM >>>
Dear list,
is there anybody out there who knows how to clean that "fogging"
effect
from the golden lenses of our DTM 2500plus sinterstations?
Thanks.
Ing. Mariapia Rossini
EOS Image S.r.l.
Via J.F.Kennedy, 44 - 25028 Verolanuova (BS) - Italia
Tel.++39 030 9361414 - Telefax ++39 030 9361426
e-mail:mprossini@eosimage.it - http:\\www.eosimage.it
For more information about the rp-ml, see http://rapid.lpt.fi/rp-ml/
For more information about the rp-ml, see http://rapid.lpt.fi/rp-ml/
This archive was generated by hypermail 2.1.4 : Tue Jan 21 2003 - 20:13:39 EET