RE: higher temp options

From: Brent Stucker (stucker@uri.edu)
Date: Tue Apr 23 2002 - 16:30:28 EEST

Next message: Richard Hague: "RE: Ceramics on LOM"
Previous message: Nico Kamperman: "Ceramics on LOM"
In reply to: bgroethe@howmet.com: "higher temp options"
Next in thread: PTMW2@aol.com: "RE: higher temp options"
Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

Bill,

I developed an inexpensive method for doing this with SLS. I process zircon
sand with a thermosetting binder and then infiltrate the part with a
high-temperature epoxy and cure in an oven. It's fast, cheap gives good
dimensional accuracy.

Brent Stucker
Univ. of RI

-----Original Message-----
From: owner-rp-ml@rapid.lpt.fi [mailto:owner-rp-ml@rapid.lpt.fi]On
Behalf Of bgroethe@howmet.com
Sent: Tuesday, April 23, 2002 7:58 AM
To: rp-ml@rapid.lpt.fi
Subject: higher temp options

We have a request for options on producing RP models that will
sustain/perform at 500 degrees F.

Suggestions?

Bill Groethe
Howmet Research Corp
231 894 7007

For more information about the rp-ml, see http://rapid.lpt.fi/rp-ml/

Next message: Richard Hague: "RE: Ceramics on LOM"
Previous message: Nico Kamperman: "Ceramics on LOM"
In reply to: bgroethe@howmet.com: "higher temp options"
Next in thread: PTMW2@aol.com: "RE: higher temp options"
Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

This archive was generated by hypermail 2.1.4 : Tue Jan 21 2003 - 20:13:43 EET