Mass properties of an STL file.

From: John Mastoloni (John.M@m2-systems.com)
Date: Thu Jul 18 2002 - 18:24:50 EEST

• Next message: Jim Williams: "RE: Blow Molder Needed"
• Previous message: joepuska@iwon.com: "3D Systems Reports Second Quarter and First Half Results"
• Next in thread: Stephane Morvan: "RE: Mass properties of an STL file."
• Reply: Stephane Morvan: "RE: Mass properties of an STL file."
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

Dear list:
    Is there any open code for finding the mass properties of an STL model?
(surface area, boundary box and volume)

Thanks
John Mastoloni
M2 Systems

200 Myrtle St
New Britain CT 06053
860-832-9331
www.m2-systems.com

For more information about the rp-ml, see http://rapid.lpt.fi/rp-ml/

• Next message: Jim Williams: "RE: Blow Molder Needed"
• Previous message: joepuska@iwon.com: "3D Systems Reports Second Quarter and First Half Results"
• Next in thread: Stephane Morvan: "RE: Mass properties of an STL file."
• Reply: Stephane Morvan: "RE: Mass properties of an STL file."
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

This archive was generated by hypermail 2.1.4 : Tue Jan 21 2003 - 20:14:02 EET