From: PT Mativenga (P.Mativenga@umist.ac.uk)
Date: Thu Oct 24 2002 - 13:10:08 EEST
Well the value you have quoted for the SLS machine seems too
high - 7.5m/sec = 450m/min. That is more than ten times the rapid
traverse speed of a good 40m/min High Speed Machining Centre.
Regards
Paul
On 24 Oct 02, at 5:18, Venkatesh Gandhi wrote:
Date sent: Thu, 24 Oct 2002 05:18:28 +0100 (BST)
From: Venkatesh Gandhi <rpfdm@yahoo.co.in>
Subject: Speed of the Machine - Reg
To: rp-ml@rapid.lpt.fi
>
> Hi Friends,
>
> I found the speed of the Fused deposition modeling machine as 26mm/sec and the solidification rate as 0.1 sec
>
> And also for Selective laser sintering machine - Speed = 7.5 m/sec
>
> Can any body conform this value.
>
> G.Venkatesh
>
> Post your ad on Yahoo! India Autos.Check out the used Maruti, Fiat and Ford models on sale now.
Dr P T Mativenga
Lecturer
University of Manchester Institute of Science and Technology
Manufacturing Division
Department of Mechanical, Aerospace and Manufacturing Engineering
Sackville Street, Main Building
P O Box No. 88, Manchester M60 1QD
United Kingdom
Tel 0161 200 3821 (overseas) 44 161 200 3821
Fax 0161 200 3803 (overseas) 44 161 200 3803
Email P.Mativenga@umist.ac.uk
This archive was generated by hypermail 2.1.4 : Tue Jan 21 2003 - 20:14:30 EET