Re: Delcam

From: Caleb Walker (caleb@kreysler.com)
Date: Fri May 30 2003 - 19:12:20 EEST

• Next message: Scott Tilton: "RE: Delcam"
• Previous message: Jonathan Chertok: "Re: ZCAST"
• In reply to: thoms1991: "Delcam"
• Next in thread: Scott Tilton: "RE: Delcam"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

Delcam is one of (if not THE) largest CAM software companies in the world, their PowerMill software runs around $20k per licenses! You can bet they have a website! Try www.delcam.com

Caleb Walker - Lead CAD/CAM

Kreysler & Assoc.
Digital Sculpture Enlargement
Architectural Composites

  ----- Original Message -----
  From: thoms1991
  To: RP-ML
  Sent: Friday, May 30, 2003 7:04 AM
  Subject: Delcam

  Does Delcam (software) have a website?

• Next message: Scott Tilton: "RE: Delcam"
• Previous message: Jonathan Chertok: "Re: ZCAST"
• In reply to: thoms1991: "Delcam"
• Next in thread: Scott Tilton: "RE: Delcam"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

This archive was generated by hypermail 2.1.7 : Sat Jan 17 2004 - 15:17:38 EET