From: Bathsheba Grossman (sheba@bathsheba.com)
Date: Sat Feb 12 2005 - 03:56:27 EET
On Fri, 11 Feb 2005, John Brock wrote:
> Rhino V3 with the new Bonus tools (www.rhino3d.com) can do the edge
> breaking and general STL mesh clean up now but there is no tools for adding
> fillets to existing meshes.
At least, not as such. You could possibly do it in Rhino by
constructing an internally radiused object on the outside of your edge
to be filleted, and then use boolean difference to perform the fillet.
But it could be a lot of work, if there were a lot of edges.
-Sheba
-- Bathsheba Grossman (831)429-8224 Sculpting geometry bathsheba.com
This archive was generated by hypermail 2.1.7 : Mon Jan 02 2006 - 08:09:06 EET