[rp-ml] Requesting info on 1 part Epoxies with viscosity less than 20cps

From: Sheku Kamara (kamara@msoe.edu)
Date: Wed Jul 06 2005 - 21:06:04 EEST

Next message: Markus Hitter: "Re: [rp-ml] Requesting info on 1 part Epoxies with viscosity less than 20cps"
Previous message: EdGrenda@aol.com: "[rp-ml] 7/5/05 Update for the Worldwide Guide to Rapid Prototyping web site"
In reply to: EdGrenda@aol.com: "[rp-ml] 7/5/05 Update for the Worldwide Guide to Rapid Prototyping web site"
Next in thread: Markus Hitter: "Re: [rp-ml] Requesting info on 1 part Epoxies with viscosity less than 20cps"
Reply: Markus Hitter: "Re: [rp-ml] Requesting info on 1 part Epoxies with viscosity less than 20cps"
Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

Hello,
I'm looking for a 1-part epoxy, preferably heat cured, with a viscosity
less than 20cps.
The goal is not only to find an epoxy with a low viscosity, approaching
water (~1cps), that seals plastic and wooden parts, but is re-usable since
part size changes.
Regards.
Sheku

Sheku Kamara
Rapid Prototyping Center
Milwaukee School of Engineering
http://www.rpc.msoe.edu

Next message: Markus Hitter: "Re: [rp-ml] Requesting info on 1 part Epoxies with viscosity less than 20cps"
Previous message: EdGrenda@aol.com: "[rp-ml] 7/5/05 Update for the Worldwide Guide to Rapid Prototyping web site"
In reply to: EdGrenda@aol.com: "[rp-ml] 7/5/05 Update for the Worldwide Guide to Rapid Prototyping web site"
Next in thread: Markus Hitter: "Re: [rp-ml] Requesting info on 1 part Epoxies with viscosity less than 20cps"
Reply: Markus Hitter: "Re: [rp-ml] Requesting info on 1 part Epoxies with viscosity less than 20cps"
Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

This archive was generated by hypermail 2.1.7 : Mon Jan 02 2006 - 08:09:14 EET