[rp-ml] Curl in Invision Parts

From: ChathamRes@aol.com
Date: Mon Jan 29 2007 - 22:58:29 EET


One of our clients had some parts produced on an Invision System. These
parts were about 8 inches long and had a bend in them that looked like the 2 x 4
's at Home Depot. In other words, they were bent considerably when you
eyeballed them.
 
Have any of the members of this list seen the same evidence of curling when
making parts longer than 6 inches?
 
I would expect that the Envision parts might have the same problem, but we
do not have any direct evidence of that.
 
 
Regards,
REL



This archive was generated by hypermail 2.1.7 : Tue Jan 01 2008 - 18:13:00 EET