[rp-ml] resin/wax for lost wax casting

From: Sanspareilics@aol.com
Date: Sat Aug 25 2007 - 08:55:27 EEST

• Next message: Ricardo Amaral: "[rp-ml] VARP 2007 - Leiria, Portugal"
• Previous message: Roger Spielman: "RE: [rp-ml] Earlier posting that didn't get through"
• Next in thread: Adrian Bowyer: "Re: [rp-ml] resin/wax for lost wax casting"
• Reply: Adrian Bowyer: "Re: [rp-ml] resin/wax for lost wax casting"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

     
 
Hi folks
 
Does anyone make a pouring resin that burns out cleanly.
 
Alternatively how thin a section ca I go down to for pouring wax under
vacuum.
 
For example I have a model with a wall thickness of about 0.75mm-1.0mm which
is fine and dandy but I want to have a rebate (think of a window frame)
which will leave a wall thickness of about 0.25mm. It only extends about 0.25mm
all round from the full wall thickness to allow an insert (like the glass in
the window frame) to locate. I will be using a vacuum casting machine.
 
Regards
            Iain

• Next message: Ricardo Amaral: "[rp-ml] VARP 2007 - Leiria, Portugal"
• Previous message: Roger Spielman: "RE: [rp-ml] Earlier posting that didn't get through"
• Next in thread: Adrian Bowyer: "Re: [rp-ml] resin/wax for lost wax casting"
• Reply: Adrian Bowyer: "Re: [rp-ml] resin/wax for lost wax casting"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

This archive was generated by hypermail 2.1.7 : Tue Jan 01 2008 - 18:13:07 EET