Andy, we have produced molds in SLS GF nylon and LaserForm ST-100 that
have been used successfully for injection molding. One of our customers
actually molded 25 pieces of Polycarbonate shot at 600 F in a GF nylon
mold we built, though I wouldn't be bold enough to say that would work
on a broad basis.
Ron Clemons
Director of Business Development
__________________________________
Harvest Technologies Inc | Belton, TX
254-933-1000 tel | 254-298-0125 fax
www.harvest-tech.com <http://www.harvest-tech.com/> | Online RFQ
<https://www.harvest-tech.com/rfq/>
"Where Innovation Takes Shape"
________________________________
From: owner-rp-ml@rapid.lpt.fi [mailto:owner-rp-ml@rapid.lpt.fi] On
Behalf Of chathamres@aol.com
Sent: Monday, May 03, 2010 9:09 PM
To: rp-ml@rapid.lpt.fi
Subject: [rp-ml] RP Material for prototype molds
What are RP systems will allow us to produce molds that can tolerate a
low pressure injection of a polymer at 325 degrees F?
Andy
This archive was generated by hypermail 2.1.8 : Fri Mar 11 2011 - 05:24:19 EET