Hello everyone,
I'm trying to find a way to manufacture a part that is 1 inch by 2 inches and has minimal flexing of the material. Trying to keep material cost under $5 per part.
Looked at objet and dimension machines, but the part flexes too much.
Are there hardening techniques that can be used for some of the machines out there without losing accuracy?
Thanks to anyone with some suggestions.
Thanks,
-Chuck
Sent via BlackBerry from T-Mobile
Received on Wed Sep 15 22:03:24 2010
This archive was generated by hypermail 2.1.8 : Fri Mar 11 2011 - 05:24:19 EET