Re: [rp-ml] problem with Zprinter

It sounds to me from the error that the software on your machine's hard drive is corrupted. Zcorp can sell you a new hard drive with the software preloaded for about $400

Rim

On Dec 22, 2010, at 5:43 PM, "The Creature Company" <mail@creaturecompany.com> wrote:

> It's been my experience that zcentral and zcorp technical service reps are very helpful and informative about all errors. Did you try them? They even offered me advice with my one test legacy machine.
>
> Lino
>
> On Wed, 22 Dec 2010 09:18:21 -0800, Yaser Shanjani <y.shanjani@gmail.com> wrote:
>
> Hello,
>
> Our ZPrinter 310plus does not work properly and keep giving the following message when we connect a monitor to the main PC board on the machine:
>
> "Fatal Error KERNEL. 146040: No waithost specified but no application present
> Setting run mode to -waithost
> Ready for debugger commands"
>
> I was wondering if anyone can advise us how to deal with this problem. Where can we find the debugger commands?
>
> Thanks,
> --
> Yaser Shanjani
>
>
>
>
> --
> Lino P. Stavole
>
> The Creature Company
>
> cell: 661.433.5283
>
> www.creaturecompany.com
>
>
>
> Important:
> This e-mail transmission, including any previous messages or attachments to it, is covered by the Electronic Communications Act, 18 U.S.C 2210-2521, is confidential and may be legally privileged. This E-mail contains information that is private, confidential, or is protected by confidentiality or non-disclosure product doctrines, and is intended only for the use of the individuals(s) names herein. If you are not the intended recipient, be advised that unauthorized use, disclosure, copying, distribution, or the taking of any action in reliance on this information is strictly prohibited. If you have received this E-mail in error, please immediately notify the sender by replying to this E-mail, and delete the original message any attachments mail@creaturecompany.com.
>
>
>
>
>
>
Received on Thu Dec 23 04:35:39 2010