In a message dated 1/1/2011 5:13:45 A.M. Eastern Standard Time,
chuck@churtle.com writes:
Hi everyone,
Happy New Year!
I'm looking for a low cost and easy to use RP machine for my personal use
and very limited commercial use. Not looking to spend a lot of time with
cleaning parts and want as close to "plug and play" as possible.
Looking at the VFlash and the uPrint, but can anyone offer some other
suggestions? I know some cool stuff must have come out of Euromold.
Not So Rigid Requirements:
* $15k Budget
* Don't care about colors
* Easy postprocessing
* Cheap Material
* Good accuracy (100 microns)
* Small build area is ok
* Slow build time is ok
Objet Alaris is out of my budget range, but seemed like a great choice.
Thanks for the help!
-Chuck Stapleton
Chuck:
Every available choice on earth selling for less than US$20,000 is listed
on this page - and don't miss the accompanying comparative table of
specifications.
Anything not listed is simply one of these sold under another name:
_http://www.additive3d.com/comp_lks.htm_
(http://www.additive3d.com/comp_lks.htm)
Happy and healthy 2011 to all!
Ed
Ed Grenda
Castle Island Co.
_EdGrenda@aol.com_ (mailto:EdGrenda@aol.com) (email)
The Worldwide Guide to Rapid Prototyping
www.additive3d.com
Received on Sat Jan 01 21:13:24 2011
This archive was generated by hypermail 2.1.8 : Sat Jan 07 2012 - 13:25:43 EET