Howdy,
I have a powder/nitrogen leak occurring between the part piston and the
piston wall on a Sinterstation 2500+ machine while running. After about
1-1.5" of material the gap fills enough that there is no visible
drainage. So far it has not affected any parts since it is off in the
front right corner (facing the machine) but I would like to resolve the
issue. Has anyone else experienced this? Any suggestions for
troubleshooting?
Thank you,
Gregory M. Paulsen
Project Engineer
Prototype Productions, Inc.
Received on Wed Aug 01 18:54:06 2012
This archive was generated by hypermail 2.1.8 : Fri Mar 29 2013 - 15:24:46 EET