Just though I would pass along a helpful trick we have learned here.
In the past we would place finished platforms of parts on a tray for
transport and cleaning. Resin would obviously get all over the tray.
Cleaning was a hassle and invariably we would clean it in our TPM tank
and speed up the saturation of it. What we figure out was to get a large
roll of the restaurant plastic wrap and cover the tray. When finished you
can just wad or roll it up - pop it in the PCA, then throw away in normal
trash. Works well for us.
Regards, Todd Stahlhut
This archive was generated by hypermail 2.1.2 : Tue Jun 05 2001 - 22:37:04 EEST