Re: STL Question

From: Brian David Vanhiel (
Date: Wed Feb 05 1997 - 07:20:59 EET

Opening your files in Ideas should work. If you have many files to
convert there is a utility called igestostl, but I am not sure of the cost
(does anyone have any more info on this? Tom Wickson are you listening?).

Brian David VanHiel
340193 Georgia Tech Station
Georgia Institute of Technology, Atlanta Georgia, 30332

On Tue, 4 Feb 1997, michael da on smithrn wrote:

> I need to convert IGES files to STL files, and was referred
> to this address. We may try opening the file in IDEAS and
> then saving as an STL, but are not sure if this will
> work. Any ideas would be extremely helpfull. This is a
> university project, so cost is of concern. Thank you for
> your time. Michael Smith, University of New Mexico

This archive was generated by hypermail 2.1.2 : Tue Jun 05 2001 - 22:39:19 EEST