Re: Benchmarking Offer

From: Floyd Roberts (
Date: Fri May 02 1997 - 20:45:50 EEST

ASTM currently has a standards committee which is actively looking for
people to participate in the development of a dimensional tollerance
standard for rapid prototyping. Anyone interested should email me at

I caution that after a number of attempts the problem is not as easy as a
first look might indicate. None the less the attempt is ongoing.
Floyd Roberts
Huntsville Al

On 4/30/97, Mark Littlewood wrote:

> Hi
> Interesting ideas for benchmarking parts. If there is the call for it, we
> will look into setting a site up on our new web-site as it comes on line,
> and running some articles in both editions of Rapid News to promote the
> concept to a wider audience than just the RP-ML. The more widely accepted
> and used the standards the better. (Right?)
> Perhaps we should put a committee of interested persons together to advise
> on the format, presentation and objectives of such a site. Any suggestions?
> Feedback required...?
> Mark Littlewood
> GM :)
> Rapid News

This archive was generated by hypermail 2.1.2 : Tue Jun 05 2001 - 22:39:32 EEST