AW: Short run tooling again

From: Jürgen Bauer (
Date: Thu Feb 05 1998 - 14:36:57 EET

Very interesting !!!

Who knows more ?

Regards, Juergen Bauer
-----Ursprüngliche Nachricht-----
Von: Masuo Namme []
Gesendet am: Dienstag, 3. Februar 1998 21:39
An: Ian Gibson;
Betreff: RE: Short run tooling again

Thanks to all the leads on short run tooling, extremely helpful, keep them

Dear Ian,

I think Teijin Seiki is one of the 1st comer who introduce this technology.
Their technology is supported by their own developing high heat resistance
As far as I know this material is best for tooling application as this can
stand up to 250 degrees Celsius.

                            Masuo Namme
                       Director Marketing
                      Shonan Design CoLtd
            TEL:81-427-75-0448 FAX:1-427-71-9744

For more information about the rp-ml, see

For more information about the rp-ml, see

This archive was generated by hypermail 2.1.2 : Tue Jun 05 2001 - 22:44:50 EEST