I suppose that you could use anything that isn't shiney........flat
finish paint of any color. Alternatively, you could change the position
where the laser rests.
> Dan Davis
> Division Head, RP&M
> Perusahaan Otomobil Nasional Berhad (PROTON)
Hicom Industrial Estate
Batu 3 PO Box 7100
Shah Alam, Selangor D. E.
> +60 3 515-3906 direct line
> +60 3 515-2380 direct fax
> +60 12 277-5770 hand phone
> From: Miller, Michael W[SMTP:Mike.Miller3@PSS.Boeing.com]
> Sent: Wednesday, 11 February, 1998 7:58 AM
> To: 'RP Mail List'
> Subject: Absorb UV Light?
> We are getting surface skinning (cured resin) in the right front
> of our SLA500 near where the laser parks between layers. Our 3d
> maintenance person believes it is caused by laser reflection off all
> resin spills on the cover plate. It has been suggested we dip the
> into hot water to soften and then remove the spilled resin. An
> alternate solution might be to paint? or apply some material in the
> that would absorb rather than reflect the UV. Any suggestions as to
> what cheap and readily available material effectively absorbs UV?
> Michael W Miller (Mike.Miller3@PSS.Boeing.com)
> The Boeing Company MS 17-PE B-XT62
> Propulsion Experimental Hardware 206-655-3289
> Rapid Prototyping 655-4366 Lab 655-4365
> For more information about the rp-ml, see http://ltk.hut.fi/rp-ml/
For more information about the rp-ml, see http://ltk.hut.fi/rp-ml/
This archive was generated by hypermail 2.1.2 : Tue Jun 05 2001 - 22:44:54 EEST