We had the same experience with our 350. Some of the resin bottles have a
thicker skin then others. The punch that is supplied with the machine is
inadequate to penetrate the plastic. Our solution was the same as yours, we
drill a small hole through the top.
> I notice that my auto resin fill is slow to fill the tank and sometimes
> Has anyone else had this problem? I just discovered that the hole punch
> for the container does not go all the way through. I drilled out the
> with .125 dia. bit. Hopefully this will correct it. If not, any ideas?
> Jim Harrison
> 3Dimensional Engineering
> You don't need to buy Internet access to use free Internet e-mail.
> Get completely free e-mail from Juno at http://www.juno.com
> Or call Juno at (800) 654-JUNO [654-5866]
> For more information about the rp-ml, see http://ltk.hut.fi/rp-ml/
-- Best Regards,
Joe DeGuglielmo Eastman Kodak Company Rapid Prototyping Center 901 Elmgrove Rd. Rochester, NY 14653-5315 (716)-726-7046 Phone (716)-726-3220 FAX email@example.com
For more information about the rp-ml, see http://ltk.hut.fi/rp-ml/
This archive was generated by hypermail 2.1.2 : Tue Jun 05 2001 - 22:45:44 EEST