Actually, it is the reflection you want, or I think (what do I know).
Anyway, the point is to have a sacrificial material to throw away and keep
the inside clean. Everyone I know turns their parts over several times
while in the PCA to assure even UV post-cure exposure.
Meanwhile, I'm writing e-mail, setting up parts, etc while my parts
post-cure slowly because aluminum foil absorbs 50% of the UV rays (but, hey,
it also REFLECTS the other 50%).
My glass is half-full, not half empty.
> From: Lynda J Hurley[SMTP:Lynda.J.Hurley@lmco.com]
> Sent: Monday, June 15, 1998 8:28 AM
> To: SiderWhite@worldnet.att.net; SDeak@hasbro.com;
> Cc: email@example.com
> Subject: Re: Keeping PCA platform clean...
> We just keep a roll of cheap wax paper next to our 3 ovens and cover the
> Change the paper as needed. By using wax paper, you will not have the
> that aluminum foil causes.
> Lynda Hurley
> Lockheed Martin
> Rapid Prototyping Lab
> Orlando, Florida
> ______________________________ Reply Separator
> Subject: RE: Keeping PCA platform clean...
> Author: firstname.lastname@example.org at MAILHUB-SMTP
> Date: 6/12/98 8:04 AM
> Good houskeeping practice, however, keep in mind that curing is
> taking place underneath, due to reflection, and that surfaces that
> reflect visible wavelengths (like chrome) do not necessarily reflect
> UV wavelengths required in post cure.
> Tom Husting
> Advantage Prototype Systems
> For more information about the rp-ml, see http://ltk.hut.fi/rp-ml/
For more information about the rp-ml, see http://ltk.hut.fi/rp-ml/
This archive was generated by hypermail 2.1.2 : Tue Jun 05 2001 - 22:45:57 EEST