Re: UNV to STL files

From: Justin R. Kidder (
Date: Fri Jun 19 1998 - 15:29:01 EEST

For everyone's information:
        In case you didn't already know, the UNV "save" option is no
longer going to be supported by SDRC in future releases of I-DEAS--I don't
know if they will still read UNV, though. In fact, I think even V 5.0
doesn't support it currently.


On Fri, 19 Jun 1998, Mauro Orio wrote:

> The conversion from UNV to STL,and it is running very well,is avaiable from CUBITAL
> since 1991.You can contact them for more information about.
> Regards
> Mauro Orio
> Promau Engineering S.r.l.
> Via per Novara ,155
> Ph. +39 0348 2258617 Direct

Justin Kidder, Research Asst. | Automation and Robotics Laboratory | University of Pittsburgh
               Home page:
         There are two rules for ultimate success in life:
                1. Never tell everything you know.

For more information about the rp-ml, see

This archive was generated by hypermail 2.1.2 : Tue Jun 05 2001 - 22:46:00 EEST