Re: Z corp

Date: Thu Jul 30 1998 - 02:51:19 EEST


We too have the Zcorp machine (Z402). Maybe we can help you with your
problem. We have been building parts since July of last year with great
success. Send me the file or call me and I will help you make good parts.

Vern Carter, CTS

-----Original Message-----
From: Bailey, Joe - GCP
To: ''
Date: Wednesday, July 29, 1998 10:53 AM
Subject: Z corp

+AD4-Hello everyone. I posted a message sometime back about Z corp. I got a
+AD4-lot of responses. We here at Graco purchased on of these machines.
+AD4-Despite the fact that we've had a lot of problems with the machine
+AD4-itself operating correctly, we haven't had much luck w/ the quality of
+AD4-the parts. Can anyone out there give any suggestions on how to get top
+AD4-quality parts from this machine? It seems to work pretty well, as long
+AD4-as the parts are solid. However, I have a thin walled part and it seems
+AD4-to warp it pretty bad. The worst part about this is, the part itself is
+AD4-too big for the build envelope, so I had to chop it up to get it built.
+AD4-Each piece was a different size, and warped very badly so they didn't
+AD4-match up. Humidity is not a problem here, we have that under control.
+AD4-Any suggestions are much appreciated.
+AD4-// Joe Bailey
+AD4-// Graco Children's Products Inc.
+AD4-// Product Development Dept.
+AD4-// Elverson, Pa 19520 (USA)
+AD4-// Email:
+AD4-For more information about the rp-ml, see

For more information about the rp-ml, see

This archive was generated by hypermail 2.1.2 : Tue Jun 05 2001 - 22:46:21 EEST