RE: 1/4-20 thread?

From: Tom Richards (
Date: Tue Mar 23 1999 - 23:24:30 EET

We've done parts with 4 x 48 NF threads on Sanders, male and female. After
chasing they fit-up fine.

At 11:37 AM 3/23/99 -0600, you wrote:
>i doubt you'll be satisfied with the result making this thread directly.
> other than with sanders and maybe actua, you will have a hard time
>creating this thread in any rp machine.
>you didn't say if it was male or female, but either way, i would recommend
>a secondary process. if it's female, model in a pilot hole, then drill and
>tap post-build. sls nylon materials machine very well, so you should have
>no problem.
>will pattison
>product development engineer
>4d design
>-----Original Message-----
>From: Ray Brandes
>Sent: Tuesday, March 23, 1999 9:49 AM
>To: Doug Bucci
>Subject: Re: 1/4-20 thread?
>I assume it is a 60deg V thread, but is it male or female? What class?
>Make the male body .25" diameter to the theoretical sharp point then
>remove .001 to .002 from the diameter.
>Make the female the same .25" to the theoretical sharp but add .001 to
>.002 to this.
>Does it have to fit an existing part? Can you make it heavy and then run
>a tap or die on it?
>Doug Bucci wrote:
>> Hello, I need to create a 1/4-20 thread in SLS can anyone provide me
>> with the minimum tolerances for creating this? Thank you,Douglas Bucci
> << File: ATT00002.html >>
>For more information about the rp-ml, see

For more information about the rp-ml, see

This archive was generated by hypermail 2.1.2 : Tue Jun 05 2001 - 22:51:19 EEST