That is what I am wondering. More specifically C-Mold 3D Quickfill, as
we are not really interested in heavy-duty CAE, just some help for some
employees of mine who are not moldmakers.
What I am looking for is some "generic" castable polyurethane that has
been tested for the following: melt-mass flow rate in grams/10minutes at
n Centigrade (probably room temp) and under n Kg load (probably
atmospheric pressure). These are the inputs required.
I think that the data output would be good enough to assist in the
design of complex silicone and/or epoxy tools.
--- Regards, Dan Davis PROTON Rapid Prototyping & Manufacturing Center Hicom Industrial Estate, Batu Tiga, PO Box 7100 Shah Alam, 40918 Selangor MALAYSIA +60 3 515-2380 phone/fax http://www.protoncar.com/rapid/index.htm
> -----Original Message----- > From: Martin CM Wong (IC) [SMTP:firstname.lastname@example.org] > Sent: Wednesday, April 21, 1999 5:12 PM > To: DANIEL@proton.com.my > Subject: Re: C-Mold > > Dear Dan, > > We are using C-mold, RIM and PU Casting, I wonder whether the viscous > elastic flow pattern of pressure injection moulding simulation package > could do the job for RIM and PU casting. > > Regards, > > Martin Wong > Industrial Centre > The Hong Kong Polytechnic University > Tel.: (852) 2766 7625 > Fax : (852) 2334 4634 > E-mail: email@example.com > > >>> DANIEL CHARLES DAVIS <DANIEL@proton.com.my> 04/21 3:59 PM >>> > Hello all, > > Is anyone out there using C-mold with RIM or castable urethanes? If > so, > can you share some generic information regarding the custom resin > specification needed for setting up the C-Mold program? TQ. > > --- > Regards, > Dan Davis > PROTON Rapid Prototyping & Manufacturing Center > Hicom Industrial Estate, Batu Tiga, PO Box 7100 > Shah Alam, 40918 Selangor MALAYSIA > +60 3 515-2380 phone/fax > http://www.protoncar.com/rapid/index.htm > > > > For more information about the rp-ml, see http://ltk.hut.fi/rp-ml/
For more information about the rp-ml, see http://ltk.hut.fi/rp-ml/
This archive was generated by hypermail 2.1.2 : Tue Jun 05 2001 - 22:51:31 EEST