Re: [build layer]

From: Spencer Onuh (
Date: Fri Feb 18 2000 - 11:31:31 EET

It depends on the setting of your build parameters. Based on the default
setting from 3D Systems, you can only build 0.15mm. But if you adjust the
build parameters, it is possible to build 0.10mm. Give a try.

"Bess Macier" <> wrote:

Can anyone tell me what the smallest build size per layer would be if you were
using 250 SLA machine?

Thanks in advance to all replies.

Bess Macier

For more information about the rp-ml, see

Spencer .O. Onuh (Ph.D)
Department of Engineering
University of Wales College, Newport
Allt-yr-yn Campus
P.O. Box 180
Newport. NP9 5XR
United Kingdom

Get free email and a permanent address at

For more information about the rp-ml, see

This archive was generated by hypermail 2.1.2 : Tue Jun 05 2001 - 23:02:51 EEST