Re: FDM 2000 question

Date: Thu Mar 23 2000 - 18:11:28 EET


If the power to your FDM2000 went out due to a tip overheating, you should
have seen a messge upon restarting, similar to "Model Temp Error"

More common in my experience, however, is a envelope temperature error.
This usually happens if I open the chamber door during a build. Opening
the door causes a sudden drop in the temperature, and the machine will
sometimes overcompensate in trying to raise the temperature. The result is
a too high chamber temperature that triggers a shut down. This too, would
be indicated upon restarting with a "Env Temp Error" message on the machine

Such interrupted builds can be recovered. The process is outlined in the
Utilities section of the manual, under the "ssrecov" section.

For more information about the rp-ml, see

This archive was generated by hypermail 2.1.2 : Tue Jun 05 2001 - 23:03:06 EEST