Re: sealing FDM parts

Date: Sun May 14 2000 - 16:34:34 EEST

In a message dated 5/12/00 12:03:02 PM Eastern Daylight Time,

<< I had on stock and mayby the problem was that this
 stuff had a too low viscosity. I placed the parts with epoxy in the vacuum
 chamber, but the layer epoxy on the part was too thick and not constant. >>
I haven't tried it, but I read once about using acetone to thin epoxy to use
as a sealant for boat models. The epoxy will still set up, but will be thin
enough to soak in.
Andy Scott
Lockheed Martin Aero Sys

For more information about the rp-ml, see

This archive was generated by hypermail 2.1.2 : Tue Jun 05 2001 - 23:03:29 EEST