Re: Thin waterjet kerf?

From: MLPC - Larry Dosser (
Date: Tue May 30 2000 - 16:41:15 EEST

Dear List:

Gem City Engineering in Dayton, Ohio manufactures a waterjet/laser
combination for Synova. The waterjet acts as a waveguide for the laser
energy. The kerf width for this system is 50 microns (0.002"), and should
meet the specified requirements. The walls of the cut are straight and the
water flow minimimzes or eliminates the heat affected zone of the laser cut.

For additional information you can contact Harry White at at Gem City
Engineering at (937) 221-5297.

Larry R. Dosser
Mound Laser and Photonics Center
(937) 865-4481 voice
(937) 865-3680 fax

For more information about the rp-ml, see

This archive was generated by hypermail 2.1.2 : Tue Jun 05 2001 - 23:03:35 EEST