I confess. I too have seen a small shift in our oldest 2000 (P017). It usually occurs somewhere around 9 or 10 inches into a build... nothing definitive and I've never paid enough attention to try to isolate the problem. I guess we better take notes on a few parameters such as Z location and maybe clock time into the build (approx) where this is occuring. Maybe we can find something in common.
Disclaimer: Engineer and out the other!
I've already told you more than I know.
Michael W Miller (email@example.com)
The Boeing Company M/C 17-PE B-2T65
Propulsion Experimental Hardware 206-655-3289
Rapid Prototyping 655-4366 Lab 655-4365
> From: Vern Carter[SMTP:firstname.lastname@example.org]
> Reply To: Vern Carter
> Sent: Thursday, June 08, 2000 2:55 PM
> To: Drew Brown
> Cc: RPML
> Subject: Re: SLS part shifting
> We have seen the same problem on our 2000 but ours is intermittent. It seems
> to shift for about an inch then it will shift back. On a 12" build we have
> seen as many as four occurrences. of this happening. I was told that the
> galvos are sticking but I never got a definitive answer or solution to fix
> the problem. I would be interested to know what you find out.
> Vern Carter
> -----Original Message-----
> From: Drew Brown <email@example.com>
> To: RPML <firstname.lastname@example.org>
> Date: Thursday, June 08, 2000 8:54 AM
> Subject: SLS part shifting
> >Recently we have experienced part shifting on one of our Sinterstations.
> >It appears that every few inches in the Z direction we see a small X-Y
> >shift in the part. Has anyone had this experience and what corrective
> >measures were taken?
> >Thanks in advance.
> >Drew Brown
> >Conceptual Reality L.L.C.
> >For more information about the rp-ml, see http://ltk.hut.fi/rp-ml/
> For more information about the rp-ml, see http://ltk.hut.fi/rp-ml/
For more information about the rp-ml, see http://ltk.hut.fi/rp-ml/
This archive was generated by hypermail 2.1.2 : Tue Jun 05 2001 - 23:03:38 EEST