RE: thermojet clean up

Date: Fri Jun 16 2000 - 17:11:36 EEST

We use a Scotch Brite pad to lighly "sand" the
support areas. We spray a minimal amount of
 "citrus cleaner" on a lapping plate. We lap the
thermojet model. The areas which do not allow
flat sanding, we spray the citrus cleaner on the
back of sand paper or a flat tool and smooth the
surfaces. Be sure to allow ample time for the
model to completely dry after sanding.

For more information about the rp-ml, see

This archive was generated by hypermail 2.1.2 : Tue Jun 05 2001 - 23:03:41 EEST