From: Robin North (
Date: Thu Jun 22 2000 - 15:53:13 EEST


Confidentiality allowing, If you would like to email the STL file to me I
will cut it for you using Solidview software.


Robin North
Arrk Formation Ltd

-----Original Message-----
Sent: 22 06 2000 10:27
To: Rp-Ml (E-mail)

Hi RP world,

I am using a thermojet and have come across the inevitable problem... Job
too big for platform.

I am told that there is a piece of software which will split the STL file
into the appropriate size pieces without having to split the original IGES
files.and thus affecting the engineering drawings.

Can anyone point me in the right direction.

Thanks in advance.

Darryl Thorne.
Apollo Fire Detectors Ltd.
36,Brookside Road,
PO9 1JR.
Tel: +44 023 9249 2412
Fax: +44 023 9249 2754

The information transmitted is intended only for the person or entity to
which it is addressed and may contain confidential and/or privileged
material. If you are not the addressee, any disclosure, reproduction,
copying, distribution, or other dissemination or use of this communication
is strictly prohibited. If you have received this transmission in error
please notify the sender immediately and then delete this e-mail.

E-mail transmission cannot be guaranteed to be secure or error free as
information could be intercepted, corrupted, lost, destroyed, arrive late or
incomplete, or contain viruses.
The sender therefore does not accept liability for any errors or omissions
in the contents of this message which arise as a result of e-mail
transmission. If verification is required please request a hard copy

For more information about the rp-ml, see

For more information about the rp-ml, see

This archive was generated by hypermail 2.1.2 : Tue Jun 05 2001 - 23:03:44 EEST