Re: SLA3500 Users Inquiry

Date: Fri Aug 11 2000 - 07:02:41 EEST

We have about the same results with our machine. Most high detail high
precision builds we must build alone in the center of the table. The closer
you get to the edges the accuracy falls off a little.
Bob Morton
Fusion Engineering

In a message dated 8/10/00 6:35:32 PM Central Daylight Time, writes:

<< For typical sla's you can get around .001 inch per inch overall accuracy
with a little work. However, feature size is limited to the spot diameter in
XY (about .010-.015 inch) and layer thickness in Z. Small spot lasers must
do better but I don't have any data on them. Hope that helps.
 Disclaimer: Engineer and out the other!
 I've already told you more than I know.
 Michael W Miller (
 The Boeing Company M/C 17-PE B-2T65
 Propulsion Experimental Hardware 206-655-3289
 Rapid Prototyping 655-4366 Lab 655-4365

For more information about the rp-ml, see

This archive was generated by hypermail 2.1.2 : Tue Jun 05 2001 - 23:04:04 EEST